Z Offset Klipperbarbara Roufs Measurements

The z_offset is the distance between the nozzle and bed when the probe triggers. Contribute to protoloft/klipper_z_calibration development by creating an account on github. Apr 5, 2023 · in klipper, z offset calibration is a basic but important procedure. Read on to learn all about how it's done! Nov 3, 2024 · it all seems to work correctly except that when setting the z offset( by z_offset_apply_probe command then save_config.

You just need to modify the 'z_offset' value in printer. cfg. This is normally under the [bltouch] section or [probe]. However the probe_calibrate test will comment that out ('#z_offset') then. Also, the z_offset in [probe] never changes. The probe_calibrate seems that it is just to work out the z_offset value, which is the difference between the probe trigger point and the nozzle a micron above the bed point. Oct 20, 2024 · but as i understood, the z home switch is not used for the z offset. For this it takes the values from the calibration probe measurement with the paper test, as described in the.